9xadStore

These are great value compared to the competitors, however, you need some extra pieces if you want to hang mountain bikes. Because mountain bikes have a more slack head tube angle, if all you use is the included hardware the bike will tilt forward and not balance. To solve this, I went to my local big box hardware store and bought some 2" x 6" 90º galvanized steel brackets to provide balance. I sanded them and painted them black. I was not always able to get the hardware into studs and used 50lb hollow wall anchors. Each bike is supported by 7 screws (3 in the upper bracket, 2 each in the lower brackets). The heaviest bike in the picture is the blue and orange mountain bike weighing in at 35lbs. There have no issues so far and everything works great.

I was looking for a Minimalist type of mounting device to both hang my bikes to get them off of the floor, and to display them on the wall in an artful way. I wanted them to look as though they were suspended on the wall with an almost invisible mounting device. The Benzo Bike Wall Mount was the perfect solution.

I attached the Venzo mount to a convenient stud near the center of the wall, but I drilled two new vertically aligned mounting holes in the mount so that both screws could be located in the center of the 2X4" stud for a more secure attachment point. Next I added two small little supports for the wheels to touch while the bike was hanging preventing the wheels from rotating up or down the wall keeping the bike level. For the supports I used simple metal angle brackets but I made 5" wide hard wood rest and attached these to the metal angle bracket and topped these with small pieces of carpet for a more esthetically pleasing appearance. The mount is very easy to use by just positioning the wall facing pedal in a vertical position, and drop it onto the Venzo mount.

The Venzo mount for me was the perfect solution and my bikes look really cool hanging on my wall when not in use.

The pedal wall hangers work fine...however, I did two things to improve them. I drilled a hole between the top two holes to allow attachment directly into the wall stud. The second addition is a must, unless you want to find your bike upside down or on the floor. You will need put an angle piece under at least the front wheel. I used a 2" X 4" aluminum angle piece under each wheel to prevent the bike rotating down and provide some wall protection.

Product needs wheel support shelves. Do yourself a favor and purchase one of the competing products here that offers the support pieces. I can’t get either bike (XC and Enduro) to stay on the wall properly without it. My wall is completely marked up now and has to be repainted. Had to custom make tire support shelves, to salvage the whole project. Bracket does seem to be well built and when attached with proper anchors (can’t use provided anchors), it will hold a bike. Too many things wrong with design and product, try something else.

This is great product and helps a lot with space saving and organization.
Recommend adding a base to protect the wall and also keep right balance ( I just put small, simple metal plates. Some bikes may have unbalanced center of gravity and bike will keep leaning down to the front. No big issue as it will not fall, but will continue to rub your wall.

Minimal addition to a wall and easy installation. These need to be mounted in a stud for strength but the brackets themselves are perfect. One thing for anyone looking to buy. These must be placed on a wall big enough for both of your tires to touch the wall while hanging. The tires are what make the 3 points of contact needed for these to work.

make sure you have plywood or 2x4 behind drywall if your going to use these
the lower bike happens to be a 55lb electric bike, holds as should

Very happy with these wall mount hangers. They work well with all the pedals I have tried. Gets the bikes up off the floor and safely out of the way. Makes the garage look super cool as well !

So far I'm very impressed. It even has a rubber cover to protect the bike pedel. Hardware kit seems good quality so far. And holding up my e-bike very well.
Would buy again.